Results 1 to 1 of 1

Thread: Multiview T-35 Firmware Version 03.13_101082 For Hardware ID (HWID) up to E02

  1. #1

    Multiview T-35 Firmware Version 03.13_101082 For Hardware ID (HWID) up to E02

    This Firmware should only be used for Multiview T-35 units with Hardware ID (HWID) up to "E02".

    The firmware is for the "fat" version of the Multiview with the 3 separate tuner inputs on the the rear panel that require "loop" cables between them.

    Multiview_back.jpg

    For models with HWID from F and above see other Firmware section

    Full details on the upgrade procedure are in the RSDEdit section.

    http://www.rsdtv.com/rcms/showthread...-the-Multiview

    Change Notes:

    1. Firmware released with EPG fix for EPG going back in time after introduction of Youview in January 2013.
    2. Default teletext mode changed to "Live Teletext" (Jan. 2014).
    3. EPG improved to allow more EPG within teletext pages to reduce the amount of pages that EPG is over (Jan. 2014).
    4. Watchdog function updated (13062014).
    Attached Files Attached Files

Similar Threads

  1. Multiview T-35 Firmware Version 03.14_101076 For Hardware ID (HWID) G & H
    By CMS_ADMIN in forum Multiview T-35 DVB-T 5 Channel Head End
    Replies: 0
    Last Post: 15th January 2014, 12:02 PM
  2. Multiview T-35 User Manual For Hardware ID (HWID) greater than "G"
    By CMS_ADMIN in forum Multiview T-35 DVB-T 5 Channel Head End
    Replies: 0
    Last Post: 26th June 2012, 10:25 PM
  3. Multiview T-35 User Manual For Hardware ID (HWID) up to "F01"
    By CMS_ADMIN in forum Multiview T-35 DVB-T 5 Channel Head End
    Replies: 0
    Last Post: 18th March 2012, 04:44 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •